Mounting Steps; Installation - BorMann BBQ4100 Instruction Manual

Table of Contents

Available languages

Remark: -SB means with side burner; Allow to put a pan on the side burner. (The diameter of pan is Max. Ф 24cm and Min. x Ф8cm)

Mounting steps

Make sure your grill is assembled properly. Detailed assembly instructions are packed with each grill giving specific assembly procedures for each model.

Follow these instructions carefully to ensure the correct and safe assembly of the grill.

Caution: Although we take every effort to ensure that the assembly process is as easy as possible, it is inherent with fabricated steel parts that corners and

edged can cause cuts if improperly handled during assembly procedures. Be careful while handling any parts during assembly. It is strongly recommended

that you protect hands with a pair of work gloves.

Preparation

You will need LPG gas bottle and proper regulators under the gas pressure to operate this gas grill. The regulators should be comply with EN16129 with

current version and national regulation.

See point 6 for farther instructions.

Energy saving tips:

a) Reduce the opening time of the lid.

b) Turn the grill off as soon as cooking is completed.

c) Preheat the gas grill for 10 to 15 minutes only. (Except for the first use)

d) Do not preheat longer then recommended.

e) Do not use a higher setting than required.

f) Connect the hose and regulator to the gas container at the left side of the gas grill .Keeping in mind that the gas container must be kept away from heat

and in a safe position .The hose dimension is 8-10mm diameter. The Length of hose recommended which shall not exceed 1.5m. The flexible hose should

comply with relevant standard and local code.

Installation

After purchasing your gas cylinder you will then be ready to set it up with your gas grill.

a) When changing the gas cylinder, it shall be carried out away from any source of ignition. Position the gas cylinder at left side of your gas grill, should not be

placed inside BBQ, keeping in mind that the bottle must be kept away from heat and in a safe position.

b) When ready to use your gas grill insert the regulator into the gas bottle valve and tighten firmly.

Warning: Before attempting to light your gas grill you must refer to your lighting instructions and warning / safety points.

Check the hose before each use, searching for cracking, cuts or any abrasions. If the hose is found to be faulty in any way do not attempt to use your gas grill.

When changing your gas bottle ensures that there are no sources of ignition close by i.e. fires, cigarettes, naked flames etc. Make sure that the appliance is

switched off.

Ensure that the hose is not subjected to twisting which will affect the gas flow when installing your gas grill. Also the hose must not have undue tension and

must not touch any part of the gas grill which may be hot.

• Please choose flexible hose whose heatproof higher than 80 oC.

• Flexible tube should be changed every 2 years. It's necessary to change the flexible tube when the national conditions require it.

How to change your cylinder

Note: Turn off the switch of cylinder (No spanner is required)

The height of the gas cylinder is below the 80cm, and the width is within 35cm

How to connect a gas bottle

a) Turn the orange cap so that the arrow is pointing to the gap in the shroud.

b) Remove the orange safety cap by pulling the lanyard out, then out. Do not use tools. Leave the cap hanging.

c) Check that the black sealing washer is fitted inside the cylinder valve. Connect the regulator to the valve.

d) Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.

Gas connector