NETGEAR WAG311 Installation Manual page 28

Installation Guide for the NETGEAR Dual Band Wireless PCI Adapter WAG311
Mount the antenna in the stand.
f.
Connect the antenna to the adapter and
position the antenna to the up position.
Reconnect the power cord and reboot the
computer.
Close the PC, attach the power cord, and
g.
follow the instructions below for your
version of Windows to proceed with
installing the software.
After a short delay, the Found New
h.
Hardware Wizard displays. Click Next
and follow the prompts to proceed.
Note: Click Yes if you are prompted
with a Windows 2000 Digital Signature
Not Found warning message.
After the installation completes, click
i.
Finish to close the wizard.
You should see the WAG311 system tray
icon on the lower right portion of the
Windows task bar.
2-10
Mount the antenna in the stand
The antenna base is magnetic. Please
Note:
be careful to place this base in a location
away from floppy disks, computer disk
drives and other devices adversely affected
by magnetism.
Add New Hardware Wizard
WAG311 System Tray Icon
Basic Setup