Table of Contents
Advertisement
InSTALLATIOn
3�9 Installation site
The location of the appliance must be determined by the
plant engineer or a competent person and must take into
account both purely technical requirements and any na-
tional/local legislation in force.
The appliance is intended to be installed inside boats.
3�9�1 Preliminary warnings
Avoid installing the unit near:
• obstacles or barriers that cause recirculation of the
exhaust air
• narrow places where the sound level of the appliance
can be enhanced by reverberations or resonances
• positioning in corners where dust and anything else
that may reduce the efficiency of the appliance by ob-
structing the air passage is usual
• environments with the presence of flammable or ex-
plosive gases
• heat sources
Avoid placing the unit within 1 metre of radio and video
equipment.
3�10 General installation diagram
1�
Unit
2�
Air inlet
3�
Air delivery
4�
Sea water inlet
5�
Sea water discharge
1
14
6�
Condensate drain
7�
Control Panel
8�
Pump
9�
Sea-side filter
10�
Ball valve
7
5
2
6
6
9
14
Make sure that:
• the installation site of the unit must be chosen with
the utmost care to guarantee adequate protection
from shocks and consequent damage
• the supporting surface can bear the weight of the
appliance
• the appliance must be installed in a position where it
can be easily serviced
• the place where the unit is to be installed is well-ven-
tilated
Some parts of the appliance produce heat during op-
eration. The room installation must ensure adequate
ventilation and proper heat dissipation.
If the appliance is installed incompletely or on an inap-
propriate base, it could cause damage to persons or
property if it should detach from its base.
Provide the following:
• a drain and a water supply nearby
• a compliant power supply nearby
• fixing elements suitable for the type of support
3
13
12
11
8
10
4
11�
Distribution channel
12�
Air distribution plenum
13�
Grids
14�
Air-side filter
3
12
13
Advertisement
Table of Contents
