Table of Contents
Advertisement
InSTALLATIOn
Down key
Up key
Allows switching between heating and cooling
functions
Allows activating or putting the device in stand-
by
The ventilation speed will be adjusted automati-
cally between a minimum and a maximum value
The ventilation speed will be reduced and the set
temperature will be changed automatically
The ventilation speed will be limited to a maxi-
mum contained value
Allows setting the maximum ventilation speed
4�1�4 General start-up
Before the activation:
4�2 Main functions
4�2�1 Operating mode set-up
to switch the operating mode
press the
key for about 2 seconds
–
The symbol
enable
The symbol
able
In heating function the symbols is alight with setpoint
higher than the room temperature.
In cooling function the symbols is alight with setpoint
lower than the room temperature.
4�2�2 Put in stand-by the control
To put in stand-by the control
press the
key for about 2 seconds
–
The control goes out.
4�2�3 Set room temperature
To set-up the temperature
operate the
–
the desired value
The displayed value change.
The room temperature set-point can range between 16
and 31 °C.
4�2�4 Automatic operation
To select the Automatic function
press the
–
The symbol
enable.
The ventilation speed is automatically adjusted between
a minimum value and a maximum value based on an al-
gorithm type PI, according to the actual distance from
the room temperature set-point.
26
on indicates the Heating function
on indicate the Cooling function en-
keys to decrease or increase
key for about 2 seconds
on indicates the Automatic function
Make sure that the remote control is connected to the
mains.
In case of a master switch on the power supply line,
switch on the system by inserting the switch.
To activate the device
press the
key
–
The symbol
lights up.
4�2�5 Medium speed ventilation function
To select the Silent operation
press the
key for about 2 seconds
–
The symbol
on indicates the Medium speed func-
tion enable
The ventilation speed is limited at a more reduced me-
dium value.
4�2�6 Minimum speed ventilation
function
To select the Night function
press the
key for about 2 seconds
–
The symbol
on indicates the Minimum speed
function enable
The ventilation speed is limited at a very low value.
4�2�7 Maximum speed ventilation
function
To select the operation at the maximum ventila-
tion speed
press the
key for about 2 seconds
–
The symbol
on indicates the Maximum speed
function enable
Maximum power output is immediately obtained both
in heating and cooling.
4�2�8 Set the key lock
To set-up the key locking
press both
keys for 2 seconds
–
The text
appearing on the display.
All settings are inhibited by the user.
Repeat the sequence to unlock the control.
Advertisement
Table of Contents
