NETGEAR ProSafe ME103 Reference Manual page 28

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point
LO CA L
1 0 / 1 0 0 M
8 7 6 5
Router, Switch, or Hub
Figure 3-3: Connecting the Ethernet cable to a router, hub, or switch
Connect an Ethernet cable from your ME103 Access Point to a LAN port (B) on your
c.
router, switch, or hub.
Note: By default, ME103 is set to be a DHCP client. If your network uses static IP
addresses, you will need to change this setting.
Connect the power adapter to the wireless access point and plug the power adapter in to a
d.
power outlet. The PWR, LAN, and Wireless LAN lights and should light up.
Connect the power adapter to the wireless access point and plug the power adapter in to a
e.
power outlet. The PWR, LAN, and Wireless LAN lights and should light up.
4 V W
ERIFY IRELESS
Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless
settings needed to connect to the ME103 (SSID, WEP, MAC ACL, 802.1x, etc.), verify
connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,
or check for file and printer access on your network.
Note: If you are unable to connect, see
3-7
ME103 802.11b
ProSafe Wireless
Access Point
E T H E R N E T
5 - 1 2 V D C
R E S E T
B
IN TER N ET
4 3 2 2 1 1 2 V D C O . 5 A
Broadband modem
C
ONNECTIVITY
Chapter 6,
August 2003
"Troubleshooting."
Basic Installation and Configuration