Default Factory Settings - NETGEAR ProSafe ME103 Reference Manual

Reference Manual for the ME103 802.11b ProSafe Wireless Access Point

Default Factory Settings

When you first receive your ME103, the default factory settings will be set as shown below. You
can restore these defaults with the Factory Default Restore switch on the rear panel — see
Wireless Access Point Rear Panel" on page
FEATURE
User Name (case sensitive)
Password (case sensitive)
Operating Mode
Access Point Name
IP Configuration
(if DHCP server is unavailable)
Network Name (SSID)
Broadcast Network Name (SSID
Radio Frequency Channel
Restricting connectivity based
on MAC Access Control List
3-3
2-7.
FACTORY DEFAULT SETTINGS
admin
password
Access Point
NETGEARxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP DHCP client
IP Address: 192.168.0.224
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Primary DNS Server: blank
Secondary DNS Server: blank
NETGEAR
Enabled
802.11b 11
WEP Disabled
Disabled
WEP Disabled
802.1x Disabled
SNMP Disabled
August 2003
Basic Installation and Configuration
"ME103