Advertisement
INSTALLATION
Before First Use
1.
Place the non-slip mat on the driver's side corner of the dashboard and then place
the head up display (HUD) on it.
2.
Connect charger to vehicle's 12V socket.
3.
Connect the cable to the OBDII input on the unit.
4.
Start the engine and the HUD will power on.
5.
The RED satellite icon will flash when charged and begin searching for a satellite
connection. When the satellite indicator turns GREEN, the HUD is ready for use.
Reflective Film
The HUD projects information up onto the windscreen. Due to the construction of your
windscreen, the HUD may create a double reflection on the windscreen, which will make it
difficult to read. If this occurs, install the reflective film.
1.
Spray some water onto the inside of your windscreen above where the HUD is
installed. Clean the area with a dry cloth.
2.
Remove the backside (marked 1) of the film and apply to the windscreen.
3.
Ensure the film is installed in the correct location and adjust if necessary.
4.
Use a flat plastic object (credit card) to squeeze out any water or bubbles from
behind the reflective film.
5.
Remove the protective film (marked 2).
6.
If the reflective film isn't positioned to display all the vehicle information, adjust the
position of the HUD and non-slip mat until it is correctly aligned.
Advertisement
