Agilent Technologies Medalist i3070 Series System Installation page 7

Example: The system is connected to a source whose output is set for 50 Vrms.
The source could be set for as high as 300 Vrms, intentionally or unintentionally.
Therefore, the external wiring connected between this source and the system must
be rated for 300 Vrms.
Maintain the System as Recommended
The recommended preventive maintenance for the system is documented in the
on- line help. Preventive Maintenance should always include testing the Emergency
Stop Switch by pressing it and verifying that all AC and DC power to the testhead
turns off.
Warning, Caution, and Note
The WARNING symbol denotes a hazard. It calls attention to a procedure, practice, or
WARNING
condition, which, if not correctly performed or adhered to, could result in personal injury
or death. Do not proceed beyond a WARNING symbol until the indicated conditions are
fully understood and met.
The CAUTION symbol denotes a hazard. It calls attention to an operating procedure, or
CAUTION
condition, which, if not correctly performed or adhered to, could result in damage to or
destruction of part or all of the product or permanent loss of data. Do not proceed beyond a
CAUTION symbol until the indicated conditions are fully understood and met.
The NOTE symbol contains important information.
NOTE
Warning and Hazard Labels
Pay attention to the following labels when they appear on the equipment.
Table 1
Label
Warning Labels on System
Description
DANGER: High Voltage
Do not detach the protective covers. Operating this equipment without
covers may cause electric shock.
WARNING: Moving Parts (General)
Do not touch the equipment while it is running. Keep clear of moving
machinery.
WARNING: Moving Parts (Hand)
Do not touch the equipment while it is running. Keep hands clear of
moving machinery.
vii