Advertisement
Your pressure washer requires some assembly and is ready
for use only after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
pressure washer, please call the pressure washer helpline
at 1-800-222-3136.
IMPORTANT: Any attempt to run the engine before it has
been serviced with the recommended oil will result in an
engine failure.
Unpack the Pressure Washer
1.
Remove everything from carton except pressure washer.
2.
Open carton completely by cutting each corner from top
to bottom.
3.
Remove pressure washer from carton.
Carton Contents
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at 1-800-222-3136.
•
The main unit
•
Handle
•
Spray gun
•
High pressure hose
•
Nozzle extension with quick connect fitting
•
Engine oil
•
Parts bag (which includes items listed below)
•
Owner's manual
•
Registration card
•
Bag containing 4 multi–colored quick connect spray
tips
•
Turbo nozzle
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolt (2)
•
Plastic Knobs (2)
Become familiar with each piece before assembling the
pressure washer. Check all contents against the illustration
on page 5. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
Assembling Your Pressure Pasher
Your Craftsman pressure washer will need assembly before
operation:
1.
Fill out and send in registration card.
2.
Attach handle.
3.
Add oil to engine crankcase.
4.
Add fuel to fuel tank.
ASSEMBLY
5.
Verify pump oil dipstick (A) has been installed into pump.
A
6.
Connect pressure hose to spray gun and pump.
7.
Connect water supply to pump.
8.
Attach nozzle extension to spray gun.
9.
Select/attach quick connect spray tip to nozzle
extension.
Attach Handle
1.
Place handle (B) onto handle supports (C) connected to
main unit. Make sure holes (D) in handle align with
holes (D) on handle supports.
D
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
2.
Insert carriage bolts (E) through holes from outside of
unit and attach a plastic knob (F) from inside of unit.
Tighten by hand.
F
3.
Insert multi–colored spray tips and turbo nozzle in
spaces provided in handle.
6
B
D
C
E
Advertisement
