Advertisement
How to Use Spray Tips
The quick–connect on the nozzle extension allows you to
switch between four different quick connect spray tips. Spray
tips can be changed while pressure washer is running once
spray gun trigger lock is engaged. The spray tips vary the
spray pattern as shown below.
Follow these instructions to change spray tips:
1.
Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holes provided in the handle.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER exchange spray tips without the trigger lock on the
spray gun engaged.
• DO NOT twist spray tips while spraying.
2.
Select desired spray tip:
•
For gentle rinse, select white 40° spray tip.
•
To scour surface, select yellow 15° or red 0° spray
tip.
•
To apply detergent, select black spray tip.
High Pressure
40° White
15° Yellow
3.
Pull back on collar, insert new spray tip and release
collar. Tug on spray tip to make sure it is securely in
place.
Usage Tips
•
For most effective cleaning, keep spray tip from 8 to
24 inches (20 to 61 cm) away from cleaning surface.
•
If you get spray tip too close, especially using a high
pressure spray tip, you may damage surface being
cleaned.
•
DO NOT get closer than 6 inches (15 cm) when cleaning
tires.
WARNING
Low Pressure
Black
Use to apply
detergent
0° Red
How to Use the Turbo Nozzle
The turbo nozzle spins a 0° nozzle stream in a circular
pattern, providing an intense wide-spray pattern for scouring
large surface areas fast and efficient.
A turbo nozzle can easily cut through heavy oil and grease
stains on concrete, brick and plastic and strip paint from
various surfaces. DO NOT use the turbo nozzle on delicate
materials, especially wood. Always start the turbo nozzle at a
distance, gradually getting closer to the surface until you get
the cleaning force you want. Always keep the turbo nozzle in
a constant motion. NEVER dwell on a single spot. Pass over
stubborn stains repeatedly until they are gone using even
strokes.
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
The turbo nozzle produces an extremely high
pressure spray which is capable of removing
paint and cutting holes through surfaces if held
too close.
• Always make sure the surface you will clean will not be damaged
by the high pressure spray by testing in a hidden area.
To attach the turbo nozzle to the spray gun:
1. Pull back collar on quick–connect and pull current spray
tip off. Store spray tips in holder provided on the handle.
2. Pull back on collar, insert turbo nozzle and release collar.
Tug on turbo nozzle to make sure it is securely in place.
3. For most effective cleaning, keep turbo nozzle from 8 to
24 inches away from cleaning surface. If you get turbo
nozzle too close, you may damage cleaning surface.
NOTE: Detergent cannot be applied with the turbo nozzle.
Cleaning and Applying Detergent
Chemicals can cause bodily injury, and/or property
damage.
• NEVER use caustic liquid with pressure washer.
• Use ONLY pressure washer safe detergents/ soaps. Follow all
manufacturers instructions.
To apply detergent, follow these steps:
1. Pull back on collar, insert black detergent nozzle and
release collar. Tug on nozzle to make sure it is securely
in place.
NOTE: Detergent cannot be applied with the high pressure
spray tips (White, Yellow, or Red).
2. Prepare detergent solution as required by job.
12
WARNING
CAUTION
Advertisement
