Assembly - Craftsman 580.752340 Operator's Manual

Your pressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners of carton from top to bottom so
the panel can be folded down flat.
• Remove fillers, accessories and parts bag shipped
with your pressure washer.
• Roll pressure washer out open end of carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• The main unit
• Handle
• Accessory tray
• Spray gun
• High pressure hose
• Nozzle extension with quick connect fitting
• Engine oil
• Parts bag (which includes items listed below)
• Operator's manual
• Registration card
• Turbo nozzle
• Bag containing 4 multi–colored ProjectPro™
nozzles
• Handle fastening hardware kit (which includes):
• Carriage bolt (2)
• Plastic knobs (2)
• Tree clips (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.

ASSEMBLY

ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach handle.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect nozzle to nozzle
extension.
Attach Handle
1. Place handle onto handle supports connected to
main unit. Make sure holes in handle align with
holes on handle supports.
Align Holes
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
6
Handle
Handle
Supports