Care And Maintenance - ultracomfort UC114 Owner's Manual

Hand Control Inside Arm Routing
To move the hand control from one side to the other, follow the
instructions below.
1. Lift the bottom of outside
back from the Velcro on
the arm cross rail.
2. Remove the hand control
wire from the J-Clip.
3. Unlock the extension
wire, and separate. Note:
This step disables all
lift chair functions.
4. Route the hand control
wire through the opposite
J-Clip.
5. Reconnect the extension
wire, and lock to secure.
Y
our lift chair will require routine maintenance checks. You can perform some
of these checks, while others may require assistance from a provider. By
following these maintenance checks, you can make sure your lift chair gives
you years of trouble-free operation. If you have any questions or concerns
regarding your lift chair's care and maintenance, contact your provider.
99Before cleaning your lift chair, consult your provider for the proper types
of cleaner and cleaning methods.
99Keep all electrical components free from moisture and liquid spills.
Intended for indoor use only.
99Periodically inspect all wiring harnesses to make sure they are not cut,
damaged, frayed, or disconnected. If damage of any type is present,
unplug the lift chair and contact your provider.
99Periodically check all fasteners for tightness, wear, and corrosion. If any
of these are present, unplug the lift chair and contact your provider.
Warning: Be careful of pinch points and sharp metal parts (wear
gloves).
99Replace the batteries after one use. Replace the batteries yearly, even if
they were not used. Batteries are intended for one use only!
J-Clip

CARE AND MAINTENANCE

P-Clip
Extension
9
Lock
Hand Control
J-Clip