CLICK ANYWHERE on THIS PAGE to RETURN TO WATER PUMP & TANK I&O & REPAIR MANUALS at
InspectApedia.com
BEFORE INSTALLING PUMP, BE SURE TO READ
THIS OWNER'S MANUAL CAREFULLY.
C A U T I O N
Fill pump with water before starting
Fill pump with water before starting
or pump will be damaged. The motor on this pump
is guaranteed by the manufacturer and in event of
failure it must be returned to an authorized service
station for repairs. Motor warranty is void if repairs
aren't made by an authorized repair station.
INSPECT THE SHIPMENT
Examine the pump when it is received to be sure
there has been no damage in shipping. Should any be
evident, report it immediately to the dealer from whom
the pump was purchased. Please check the pump
package to see that it includes pump, motor, and
motor leads (if your pump purchase includes a motor).
Make certain that your available voltage corresponds
to that of your motor.
4" ENVIRONMENTAL
E-SERIES PUMPS
OWNER'S MANUAL
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury:
D A N G E R
serious personal injury, death or major property
damage if ignored.
W A R N I N G
serious personal injury, death or major property
damage if ignored.
C A U T I O N
cause minor personal injury or major property damage
if ignored.
The label NOTICE indicates special instructions, which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
WA R N I N G
Hazardous voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting to power
supply. Disconnect
power before working
on pump, motor
or tank.
connecting motor to power lines.
ATTENTION!
IMPORTANT INFORMATION FOR INSTALLERS OF
THIS EQUIPMENT!
THIS EQUIPMENT IS INTENDED FOR INSTALLATION
warns about hazards that will cause
warns about hazards that can cause
warns about hazards that will or can
manual and on pump.
Keep safety labels in good
condition.
Replace missing or damaged
safety labels.
Wire motor for correct
voltage. See "Electrical"
section of this manual and
motor nameplate.
Ground motor before
connecting to power supply.
Meet National Electrical
Code, Canadian Electrical
Code and local codes for all
wiring.
Follow wiring instructions
in this manual when
106259101 Rev.2 6/12