Advertisement
Quick Links
40201043
TSD450 LCDC
QUICK START
Transmission Fluid Exchange
INSTRUCTIONS
Machine with Chemical Injection
OPERATION
NOTE: This machine is fully interactive. Always follow the on-screen instructions.
SAFETY RECOMMENDATIONS
Use extreme safety measures when working around a running engine.
Always block the vehicle's drive wheels.
Ventilate the vehicle's exhaust.
Always wear safety glasses.
It's a good idea to wear gloves.
PREPARATION
Road test the vehicle for at least one mile.
Make sure there are no problems with the transmission
such as leaks, low fluid level, shifting issues, etc.
Connect battery cables to vehicle's battery.
PERFORMING A DIPSTICK EXCHANGE
Press 2 for Dipstick Exchange.
Add Transmission Cleaner.
See "Adding Chemicals" section.
Press 1 for Normal Exchange. When this is selected, the
machine will complete the exchange without prompting you
to change the vehicle's transmission filter.
Press 2 for Filter Replacement. When this is selected, the
machine will pause during the exchange and prompt you to
change the vehicle's transmission filter. Follow the on-
screen instructions.
Connect red and gray service hoses to chrome manifold.
Insert nylon tube down dipstick tube the same length as the
dipstick, being cautious not to insert too far.
Use the yellow ▲▼ arrow keys to select the desired
amount to be exchanged. Press the green button to
proceed.
Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874
Page 1 of 6
Advertisement
Related Manuals for FLO-DYNAMICS TSD450 LCDC
Summary of Contents for FLO-DYNAMICS TSD450 LCDC
- Page 1 Use the yellow ▲▼ arrow keys to select the desired amount to be exchanged. Press the green button to proceed. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 1 of 6...
- Page 2 Then press the Green Button to begin the exchange. Once the exchange is finished, the screen will beep and display “Complete”. Add Transmission Treatment. See “Adding Chemicals” section. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 2 of 6...
- Page 3 If the exchange stops and the display reads “Halted – Shift to Neutral”, set the vehicle’s parking brake, shift to neutral, and press the Green Button to resume the exchange. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 3 of 6...
-
Page 4: Adding Chemicals
The fluid level in the vehicle will be adjusted automatically based on the volume of chemicals used. Perform the normal final fluid level adjustment after the exchange is completed. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 4 of 6... -
Page 5: Additional Functions
You must push the Red Button on the control panel when the machine begins to pump air out of the red service hose. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 5 of 6... - Page 6 Button. The exchange will resume where it left off. CYCLE VALVES From the main menu, press ▼ to proceed to the next menu. Press 9 to cycle the valves. Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874 Page 6 of 6...