FLO-DYNAMICS VacFill3+ Basic Operational Overview

VacFill
IMPORTANT: Machine needs at least 115psi of air to operate.
SUCTION WAND PROCEDURE:
1. Connect Wand Adapter to Black Service Hose & open Ball Valve.
2. Turn Overflow Valve on back of machine to "Normal Service Position".
3. Turn Right Dial to "Vacuum/Drain Waste" position.
4. Flip Switch to "Air On" position to start.
5. Flip Switch to "Off" position when finished.
REMOVE & FILL PROCEDURE:
1. Make sure vehicle is turned off, but at operating temperature.
2. Turn Overflow Valve on back of machine to "Normal Service Position".
3. Connect Wand Adapter to Black Service Hose, open Ball Valve, flip Switch to "Air On"
position and Right Dial to "Vacuum/Drain Waste" position to remove waste fluid from
overflow bottle.
4. When overflow bottle is empty, flip Switch to "Off" position.
5. Remove radiator cap.
6. Connect Cone Adapter to Black Service Hose.
7. Turn Right Dial to "Vacuum/Drain Waste" position.
8. Flip switch to "Air On" position.
9. Open Ball Valve on Black Service Hose.
10. Insert Cone Adapter into radiator, making sure the tip of the cone is submerged.
HINT: If servicing from bottle, insert a hose into the cone long enough to reach
near the bottom of the bottle (hose not supplied).
For technical support, call:
Flo-Dynamics
1-800-303-5874
3
+
Basic Operational Overview
™
941457