Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for FLO-DYNAMICS TS650M
Summary of Contents for FLO-DYNAMICS TS650M
-
Page 2: Table Of Contents
Table of Contents Flo-Dynamics ® TS650M™ TABLE OF CONTENTS INTRODUCTION to the TS650M ..........3 SAFETY INFORMATION ............4 Important Safety Notice........4 - Section 1.01: Important Safety Instructions....... 6 - Section 1.02: II. SYSTEM FEATURES & SPECIFICATIONS ......10 Features……………………………………………..10 - Section 2.01:... -
Page 3: Introduction To The Ts650M
15,000 miles (or according to the vehicle owner’s manual). The Flo- Dynamics TS650M exchanges virtually all of the used transmission fluid to new, without even requiring the transmission pan to be dropped. There is no spillage, and no mess. -
Page 4: Safety Information
1.01 IMPORTANT SAFETY NOTICE For your safety, read this manual thoroughly before operating your TS650M unit. Your TS650M unit is intended for use by properly trained, skilled professional automotive technicians. The safety messages presented below and throughout this user’s manual are reminders to the operator to exercise care when using this unit. - Page 5 Risk of Fire Read Instructions Before Use Risk of Explosion Mandatory Eye Protection Risk of Entanglement Mandatory Protective Gloves Dangerous Fumes Mandatory Protective Clothing Tipping Hazard Mandatory Ear Protection Slipping Hazard Team Lift Operations Manual Printed in the U.S.A. for Flo-Dynamics ®...
-
Page 6: Section 1.02: Important Safety Instructions
Improper use and operation. • Read, understand and follow all safety messages and operational procedures in this manual before operating the Flo-Dynamics TS650M. • This equipment should be operated only by qualified personnel. • Use this equipment only as described in this manual. - Page 7 Contact with moving parts can cause injury. Risk of fire or explosion. • Do not operate the TS650M in the vicinity of open containers of flammable liquids such as gasoline. • Keep hoses and jumper cables away from heat sources and sharp edges.
- Page 8 “Appendix C – Replacement Parts” to order new hoses. • The use of any other accessories not specified in this manual may create a hazard. Tools that slip or break can cause injury. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®...
- Page 9 • Care should be taken to arrange the battery cables and service hoses so that they will not be tripped over or pulled. • Never pull on the power cables or service hoses to transport the TS650M. Damage may occur to these components, or machine may tip over.
-
Page 10: System Features & Specifications
• Totalizer check (indicates lifetime use) • Interactive menu: - “Auto Prime” feature automatically primes the system - Indicate new fluid volume - Indicate used fluid capacity - Read battery voltage Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 11: Section 2.02: Dimensions & Technical Specifications
Power: 150W Max. Hydraulic Working Pressure: 60 PSI/ 4.1 Bars Fluid Sensors: Accurate sensor technology Filters: 22-micron absolute fluid filters Operating Temperature: 60º to 150ºF (15º to 65ºC) Year of Construction: 2010 Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 12: Section 2.03: Environmental, Transportation & Handling
-25 C to +55 C and for short periods up to +70 It has been packaged to prevent damage from the effects of normal humidity, vibration and shock. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 13: Machine Overview
Flo-Dynamics ® TS650M™ II. System Features & Specifications 2.04 MACHINE OVERVIEW * Actual machine may not contain the features depicted and may vary from photos. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 14: Operating Procedures
Standard 10 mm 1 long 1 long 11 mm 1 short 1 short 12 mm 13 mm 14 mm 15 mm 16 mm 17 mm 18 mm 19 mm 20 mm Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... - Page 15 WARNING • Wear safety goggles and protective clothing, user and bystander. • Do not operate the TS650M in the vicinity of open containers of flammable liquids such as gasoline. • This machine is equipped to operate on 12-volt DC power only.
-
Page 16: Section 3.02: Basic Operating Instructions
8. When exchange is finished, the unit will beep and display “Complete”. 9. You may top off or remove fluid by using the “ADD FLUID” or “REMOVE FLUID” buttons. 10. Press 0 to return to the main menu. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... - Page 17 You may top off or remove fluid by using the “ADD FLUID” or “REMOVE FLUID” buttons. Press 0 to return to the main menu. Shut off engine and disconnect hoses and adapters from vehicle Reconnect fittings Start Engine and check for leaks. Check fluid level. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®...
-
Page 18: Section 3.03: Additional Instructions
1. Shift vehicle to neutral 2. Press START 3.04 TECHNICAL SUPPORT CONTACT INFORMATION If you experience any problems or have any questions, call technical support at: 800-303-5874, 574-262-3400 or e-mail fcasale@norcoind.com Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 19: Hoses & Adapters
941802 (Mates with #51) Used for draining the tanks - Hose #59 941809 4.02 ADAPTERS 940831 941747W 941748W Master Hose Connector Mercedes Master Connector Mercedes Master Connector Male Coupler Female Coupler Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 20: Troubleshooting & Maintenance
This helps eliminate surface tension caused by debris and contamination from the air. Using a sharp pick, remove screen. Clean using degreaser and brush, and blow out with air compressor. • Periodically Wipe Down Exterior using a soft, damp cloth. Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 21: Replacement Parts
Wall Mounted Hose Rack (Adapters Not Included) 941220 Locking Caster Wheel R942118 10” Wheel 941300 Canister Filter 940796A New Fluid Screen R942129 Operations Manual 941740 Quick Start Instructions 941742 Quick Start Instructions: Additional Functions 941743 Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 22: Section 6.02: Replacement Part Illustrations
VI. Replacement Parts Flo-Dynamics ® TS650M™ 6.02 REPLACEMENT PART ILLUSTRATIONS Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 23: Section 6.03: Ordering Information
Flo-Dynamics ® TS650M™ VI. Replacement Parts 6.03 ORDERING INFORMATION To order replacement parts for the Flo-Dynamics TS650M, call: 800-303-5874, 574-262-3400 or mgehrke@norcoind.com Operations Manual Printed in the U.S.A. for Flo-Dynamics ®... -
Page 24: Limited Warranty
LIMITED ONE (1) YEAR WARRANTY Flo-Dynamics TS650M Flo-Dynamics warrants only to the original Purchaser that under normal use, care and service, the Equipment (except as otherwise provided herein) shall be free from defects in material and workmanship for one year from the date of original invoice. External hoses, remote control modules, adapters and all other attachments, supplies and consumables (except as otherwise provided herein) are warranted for 90 calendar days from the date of original invoice.