Setting The Rear Output And Subwoofer Controller; Switching The Telephone Muting/Attenuation - Pioneer KEH-P7035 Operation Manual

Initial Settings
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :FULL) or subwoofer
(Rear SP :S.W) connection. If you switch the
rear output setting to the Rear SP :S.W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :FULL). When rear out-
put are connected to full range speakers
(when Rear SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
phase) built-in S.W Control:INT or the auxili-
ary S.W Control:EXT.
1 Press FUNCTION to select Rear SP.
Press FUNCTION repeatedly until Rear SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
Rear SP :FULL (full-range speaker) and
Rear SP :S.W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S.W.
# When the rear output setting is Rear SP :S.W,
you cannot change the subwoofer controller.
3 Press c or d to switch the subwoofer
output or non fading output (full-range
RCA output).
Pressing c or d will switch between
S.W Control:INT and S.W Control:EXT and
that status will be displayed.
HHHHHHHHHHHHHH
All manuals and user guides at all-guides.com
Notes
! Even if you change this setting, there is no
output unless you turn the non fading output
(refer to Using non fading output on page 27)
or subwoofer output (refer to Using subwoofer
output on page 26) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
! The sound is turned off, MUTE or ATT is
displayed and no audio adjustment is pos-
sible.
! Operation returns to normal when the
phone connection is ended.
1 Press FUNCTION to select Telephone.
Press FUNCTION repeatedly until Telephone
appears in the display.
2 Press c or d to switch the telephone
muting/attenuation.
Pressing c or d will switch between
Telephone :ATT (attenuation) and
Telephone :MUTE (muting) and that status
will be displayed.
Section
08
31
En