Table of Contents
Advertisement
Before You Start
Release button
3
Put the front panel into the protective
case provided for safe keeping.
Attaching the front panel
1
Make sure the inner cover is closed.
2
Replace the front panel by clipping it
into place.
Switching the DSP setting
mode
This unit features two operation modes: the 3-
way network mode (NW) and the standard
mode (STD). You can switch between modes
as desired. Initially, the DSP setting is set to
the standard mode (STD).
! After switching, reset the microprocessor.
WARNING
Do not use the unit in standard mode when a
speaker system for 3-way network mode is con-
nected to this unit. This may cause damage to
the speakers.
% Use a thin standard tip screwdriver to
switch the DSP switch on the bottom of
this unit.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
% Press RESET on the head unit with a
pen tip or other pointed instrument.
RESET button
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus () poles pointing in the proper di-
rection.
Section
01
7
En
Advertisement
Table of Contents
