Table of Contents
Advertisement
Your Fisher & Paykel ActiveSmart™ refrigerator is fitted with front and rear rollers to allow
you to easily move your refrigerator forward and backward. Avoid moving your refrigerator
sideways to prevent damaging the rollers or the floor covering surface.
Your refrigerator will arrive with the front feet wound up to assist with moving the product
into its final location.
1
2
Levelling of refrigerator doors
1
POSITIONING YOUR REFRIGERATOR
Roll the refrigerator into its final
position ensuring there is the correct
air gap between the product and
surrounding cabinetry. See minimum
clearance in cabinetry dimensions table.
Adjust the front feet down until the
refrigerator is leaning backward with
the front approximately 10mm higher
than the back. This will ensure a good
door closing action.
Open the door that is out of alignment.
Lift the door upwards.
Clip the spacer onto the centre
hinge pin.
Close the door to recheck alignment.
What to do if your product is unstable
1
2
3
Gently push the refrigerator back until
the rear rollers contact the floor.
Measure the gap under the front foot,
which has come off the floor.
Obtain some solid packing material
(hardwood, plastic, etc) which fits firmly
into the gap under the foot.
Wind both front feet up and roll the
product out of position.
Place the packing material in the
location diagonally opposite the front
roller that lifts off the floor.
Ensure the packing material stays in
place when the product is pushed back
into position.
Roll the refrigerator back into position
and adjust front feet. Check alignment
and door closing action are satifactory.
Make small adjustments to the front
feet where necessary.
13
Advertisement
Table of Contents
