Getting Started
1
Door Operation
□ To enter the bath, lift the latch and push the door
open. Close the latch to secure the door.
□ To exit the bath, drain the water completely before
lifting the latch to open the door.
NOTE: The door will not open when the bath is fi lled
with water.
2
Back and Neck Heater
Press the heater control pad to operate the heater:
Turn on and off
Heat level indicator: low (yellow),
medium (orange), high (red)
Increase temperature
Decrease temperature
3
Drain Operation
Turn the lever handle to open and close the drain.
4
Multifunction Handshower
Push the tab to select one of three handshower
spray options.
5
Handrails
Internal and external handrails ease movement in
and out of the bath.
*Features can run simultaneously.
©2016 Kohler Co.
Hydrotherapy
6
BubbleMassage
Control
™
Fill the bath at least 4" (102 mm) above the airjets.
Press the bubble control button to turn bubbles on,
change speed, and turn off:
□ First press: intense bubbles from all airjets
□ Second press: moderate bubbles from all airjets
□ Third press: low bubbles from back airjets only
□ Fourth press: turn bubbles off
NOTE: This feature automatically turns off after 20
minutes.
NOTE: An automatic water purge cycle begins 30
minutes after the bath is turned off and drained. The
cycle runs for 1 minute.
Whirlpool Control
7
Fill the bath at least 2" (51 mm) above the highest jet.
Press the whirlpool control button to turn the jets
on or off.
8
Whirlpool Jets
Position each jet nozzle in the desired direction.
Turn the jet ring to select intensity options:
□ Clockwise: decrease intensity
□ Counterclockwise: increase intensity
Need Help?
Contact your KOHLER-certifi ed dealer: ____________
KOHLER Customer Care Center: 1-800-4KOHLER
1287866-5-A
Need help?
Do you have a question about the Walk-In Bath and is the answer not in the manual?
Questions and answers
water jets turn on by self . how to remedy
The Kohler Walk-In Bath has an automatic water purge cycle that begins 30 minutes after the bath is turned off and drained. This cycle activates the water jets for 1 minute to clean the system. This is normal operation and not a malfunction. No fix is needed unless the jets activate outside of this cycle, in which case service may be required.
This answer is automatically generated
how many gallons to fill it up
The average Kohler Walk-In Bath can hold up to 50 gallons of water.
This answer is automatically generated
where are the filters located
We had a premier care tub installed and the door is damaged & leaking badly. I haven’t been able to contact them & fear they are out of business. Can you confirm that