Craftmade Insight IST52 Installation Manual
  1. Manuals
  2. Brands
  3. Craftmade Manuals
  4. Fan
  5. Insight IST52
  6. Installation manual

Craftmade Insight IST52 Installation Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Insight
Installation Guide
For Model:
IST52
4007498
net weight of fan: 19.62 lb (8.9 kg)
READ THESE INSTRUCTIONS
AND SAVE THEM FOR FUTURE USE

Table of Contents:

Wiring. pg. 5
Warranty. pg. 8
page 1
PRINTED IN CHINA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Insight IST52 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Craftmade Insight IST52

Summary of Contents for Craftmade Insight IST52

  • Page 1: Table Of Contents

    READ THESE INSTRUCTIONS AND SAVE THEM FOR FUTURE USE Insight Installation Guide For Model: IST52 Table of Contents: Safety Tips. pg. 2 Unpacking Your Fan. pg. 3 Parts Inventory. pg. 3 Installation Preparation. pg. 4 Mounting Plate Installation. pg. 4 Preparation for Wiring.

  • Page 2: Safety Tips

    (2) this LED light kit must accept any interference received, including interference that may cause undesired operation. Distributed by: Craftmade, 3901 S 20 Avenue, DFW Airport, TX, 75261; 1-800-486-4892 NOTE: The important safety precautions and instructions appearing in the manual are not meant to cover all possible conditions and situations that may occur.

  • Page 3: Unpacking Your Fan

    1. Unpacking Your Fan. Carefully open the packaging. Remove items from Styrofoam inserts. Remove motor housing and place on carpet or Styrofoam to avoid damage to finish. Do not discard fan carton or Styrofoam inserts should this fan need to be returned for repairs. Check against parts inventory that all parts have been included.

  • Page 4: Installation Preparation

    3. Installation Preparation. blade edge To prevent personal injury and damage, ensure that inches 7 feet (76cm) the hanging location allows the blades a clearance of (2.13m) 7ft. (2.13m) from the floor and 30in. (76cm) from any wall or obstruction. This fan is suitable for room sizes up to 400 square 12 ft.

  • Page 5: Preparation For Wiring

    5. Preparation for Wiring. safety wood cable joist loop wood screw Lift motor assembly to mounting plate and then hang and washer motor assembly on j-hook on underside of mounting plate. (Use one of the rectangular openings on the topside of the motor assembly to do so.) This will allow motor assembly to hang out of the way while wiring.

  • Page 6: Fan Assembly

    7. Fan Assembly. mounting plate Remove motor assembly from j-hook on mounting plate. Lift motor assembly to mounting plate. Align 2 slotted holes at top of motor assembly with loosened screws in mounting plate. Twist motor rectangular slotted hole opening assembly to lock.

  • Page 7: Light Kit Assembly

    9. Light Kit Assembly. motor housing Remove 1 screw from motor plate on underside of motor assembly and partially loosen the other 2 screws. Align slotted holes in center of shade with loosened screws in motor plate, allowing male plug from motor assembly to come through hole in middle motor of shade.

  • Page 8: Troubleshooting

    Troubleshooting. Warranty. WARNING: Failure to disconnect power supply prior to CRAFTMADE LIMITED LIFETIME WARRANTY: CRAFTMADE warrants this fan for use as intended under troubleshooting any wiring issues may result in serious the following provision: CRAFTMADE will replace any fan injury.

Table of Contents