Scope Of Delivery - Dometic DELIBOX DEL90H Installation And Operating Manual

EN
DEL90HC only
WARNING! Explosion hazard
Do not store any explosive substances, such as spray cans with propellants, in the device.
CAUTION! Electrocution hazard
• Disconnect the device from the power supply before each cleaning and maintenance.
• Disconnect the device from the power supply after every use.
WARNING! Fire hazard
• Switch off the device in the event of any damage to the refrigerant circuit.
• Avoid naked flames and sparks in the event of any damage to the refrigerant circuit.
• Air ventilate the room well in the event of any damage to the refrigerant circuit.
• Keep the ventilation openings on the device housing free of obstructions.
• Do not damage the refrigerant circuit.
• Do not use electrical devices in the food compartments of the cooler unless they are recommended
by the manufacturer for this purpose.
• Do not place any caustic materials or materials containing solvents in the device.
WARNING! Health hazard
• Children aged from 3 to 8 years allowed to load and unload the appliance.
• Check if the cooling capacity of the device is suitable for storing the food you wish to cool.
• Check if the heating capacity of the device is suitable for storing the food you wish to heat.
• Opening the door for long periods can cause significant increase of the temperature in the compart-
ments of the device while the cooling mode is on.
• Opening the door for a longer period can cause a significant decrease temperature in the compart-
ments of the device while the heating mode is on.
• Switch off the device if it is le empty for a long period.
• Defrost the device if it is le empty for a long period.
• Clean and dry the device if it is le empty for a long period.
• Leave the door open to prevent mold developing within the device if it is le empty for a long peri-
od.
NOTICE! Damage hazard
• Do not open the refrigerant circuit under any circumstances.
• Only carry the device upright.
• Do not place the device near naked flames or other heat sources (heaters, direct sunlight, gas ovens
etc.).
• Check that the voltage specification on the data plate is the same as that of the power supply.

4 Scope of delivery

fig.  on page 1
12