Automatic Operation - Imit Chronomix S Manual

Chronomix S - Imit Control System s.r.l.
Set the desired temperature: position the desired value under the reference indicator by turning the Comfort
knob (Fig.1 B).

AUTOMATIC OPERATION

The temperature regulated in the environment (set with the Comfort or Reduced knobs) depends on the settings
chosen on the clock and changes automatically.
Position the selector (Fig.1 C) on the symbol
Set the comfort temperature: position the desired value under the reference indicator by turning the Comfort
knob (Fig.1 B).
Set the reduced temperature: position the desired value under the reference indicator by turning the reduced
temperature knob
Program the clock by positioning the levers (Fig.1 F):
• outwards for the comfort temperature
• towards the centre for reduced temperature
Check that the index of the clock shows the current time and if necessary proceed as indicated in chapter
"CLOCK ADJUSTMENT".
REGULATION TYPE (Reserved for installers)
The position of the jumpers A and B (Fig.8) allows the device to work with two different types of temperature
regulation:
• ON / OFF (factory setting): The device is activated when the ambient temperature is lower than the temperature
set and turns off when it reaches the temperature set.
A=Present, B= Present
• TPI: The device is activated when the ambient temperature is lower than the temperature set and, approaching
the required temperature, reduces the operating periods of the boiler, optimising environmental comfort and
reducing energy consumption.
A=Absent, B=Present (optimised for radiator systems) A=Absent, B=Absent (optimised for �oor
systems)IMPORTANT: repositioning of the jumpers must be performed before inserting the batteries or in any
case with the device with batteries removed.
8 of 9
(Fig.1 A).
;
FIG. 8
https://manimit.it/en/chronomix-s-2/
1/27/2022, 11:35 AM