Operation - Haverland CHT-180 Instruction & Installation Manual

EN

2. OPERATION

2.1 OPERATION
ON/OFF
Heat
1. Connect to any 220-240V, 50Hz, AC source. Press the Power
switch at back side, the heater is on standby, LED will display
room temperature, then please use the remote control or the
button on the control panel to operate.
2. Press the "ON/OFF Heat" button on the control panel of the
heater once or press the "ON/OFF" button on the remote
control, the indicator heat light will turn blue, and high heating
air will be release.
3. Press the "ON/OFF Heat" button on the control panel of the
heater twice, or press the "Heat" button on the remote control,
the indicator heat light will turn to green, and blow the high
heating wind.
4. Press the "ON/OFF Heat" button on the control panel of the
heater for a third time, or press the "ON/OFF" button on the
remote control, to stop the heating. After the air comes out for
about 15 seconds, the grill closes. Product in standby.
5. When the product is working, press the "Swing" button on the
control panel or on the remote controller once, the indicator
light on the remote controller once. Press the button twice, the
CHT180
16
Swing Timer
Temperature