Table of Contents
Advertisement
Available languages
Available languages
EN
2. INSTRUCTIONS FOR INSTALLATION
4
Screw the four
brackets to the rear
part of the radiator
with the four screws.
5
Place the radiator
in the wall supports
until to ear "clicks" to
secure the radiator
to the wall.
6
Press ON / OFF
switch located
at the right rear
part of the unit.
ECOVIEW / ECOVIEW S
20
7
Plug in
3 pin 13 amp
plug.
3. OPERATION
2.2 INSTALLLING THE FEET:
Screw the two feet
to the lower rear part
of the radiator with
the two screws.
3.1 CONTROLS
3.2 MANUAL MODE
* Press the ON/OFF button located on the right side.The appliance has a built in thermostat that
can be regulated and it controls the temperature.
* The "In operation" indicator LED will turn on indicating that the radiator is working.
* To settle the room temperature, turn the electronic thermostat control knob to the desired
position. The electronic thermostat will maintain a constant temperature.
* The thermostat has an antifreeze position. With the thermostat control at minimum, the
appliance will start working when the room temperature goes down to 5ºC.
NOTE 1
The background colour of the "in operation" indicator LED will change when
the pre-set temperature is modified or changed, indicating the selected
temperature range to the user by showing:
Red
•
if the temperature is over 24ºC
•
Yellow
if it is higher than 19º and up to 24ºC
•
Green
if it is equal to or lower than 19ºC
Blue
•
if it is equal to or lower than 5ºC
EN
1. Ambient Thermostat Knob
2. "In operation" Indicator LED
3. "Bluetooth
®
" Indicator LED
4. Antifreeze Mode
5. Comfort Mode
6. AUTO "Bluetooth
®
" Mode
ECOVIEW / ECOVIEW S
21
EN
Advertisement
Table of Contents
