Table of Contents Safety Information ..............................3 Alert Signals..............................3 Warnings ..............................3 Introduction................................4 Intended Use ..............................4 Principles of Operation ..........................4 Installation ................................5 Site Selection..............................5 Operation ................................6 General Specifications..........................6 Ordering Procedures ............................7 Two Year Limited Warranty ..........................8...
Alert Signals tion. You must carefully read and understand the contents of this manual prior to the use of this equipment. Your Thermo Scientific Thermolyne Hot Plate has been Warning designed with function, reliability, and safety in mind. It is your...
Introduction Intended Use Note The Model HP11500B Hot Plate is UL Listed and has been The Type HP11500 Hot Plate is UL designed to meet OSHA and other safety standards. It is Listed explosion-proof for Class 1, used for procedures requiring temperatures from ambient to Group D locations where flammable 428°F (220°C).
Installation Site Selection Caution Install hot plate on a level, sturdy surface and allow space for Minimum allowable spacing between ventilation. hot plate and any vertical surface is one inch. The electrical specifications are located on the back of the hot plate.
Operation Warning To prevent ignition of hazardous atmospheres, assembly must be Power Control kept tightly sealed at all times. The power is turned ON or OFF by means of the dial knob. The power is ON when the dial is at or near the “ON” mark “Caution: Hot Surface.
Ordering Procedures Please refer to the Specification Plate for the complete model number, serial number, and series number when requesting service, replacement parts or in any corre- spondence concerning this unit. All parts listed herein may be ordered from the Thermo Scientific dealer from whom you purchased this unit or can be obtained promptly from the factory.
(ii) misuse (including use inconsistent with written operating instructions for the product), mishandling, contamination, overheating, modification or alteration of the product by any customer or third party or (iii) use of replacement parts that are obtained from a party who is not an authorized dealer of Thermo Scientific prod- ucts.