Coleman 5100 LP Gas Series Assembly Manual page 24

NOTE: Step 20 applies to you only if your grill is set up from the factory to use LP GAS. If your grill is set up from the factory to
use NATURAL GAS, skip to Step 21.
Step
20
20-A
LP Cylinder
Cylinder Support
20-A. Set LP Cylinder in the Cylinder Support with the outlet
valve facing toward the front of the grill.
20-B
20-B. Tighten the Cylinder Hold-Down Bolt against the bottom
cylinder collar.
24
Attach an LP Cylinder to the
Grill.
Cylinder Hold-Down Bolt
20-C
Type 1 Nipple
20-C. Insert the TYPE 1 Nipple of the regulator into the cylin-
der's Fuel Valve Outlet as shown. Turn the regulator
hand wheel clockwise to tighten. No tools are needed.
The hand wheel will come to a complete stop when the
connection is secure, and gas will not flow until a positive
seal is achieved.
IMPORTANT!
T
O ENSURE PROPER GAS FLOW
CONTROL VALVES MUST BE
OPENING THE GAS CYLINDER VALVE
WARNING:
grill and when attaching or replacing the
L.P. gas cylinder, insure that the gas sup-
ply hose is free of kinks and/or damage
and is at least 3" away from hot surfaces
such as the grill casting.
Fuel Valve Outlet
,
BURNER
"OFF"
BEFORE
.
During assembly of