Step
7
Hardware shown actual size
(CX)
M6 x 20mm Screw
(5) Qty.
7-A
FIREBOX
7-A. Lay the Firebox on it's backside with lid closed . This
will allow easy access to the fastener locations.
Assemble the Right Side Table to the Firebox with
five Screws (CX) and one Locking Hex Nut (UO).
Place the Locking Hex Nut in the center position as
shown in 7-C.
Tighten all fasteners.
12
NOTE: Use a ground cloth
to protect the paint finish
during Step 7 and 8.
Assemble Right Side Table
to the Firebox.
(UO)
M6 Locking Hex Nut
(1) Qty.
RIGHT
SIDE
TABLE
7-B
CX (x2)
7-C
CX
7-D
UO
CX (x2)