Installing The Unit; Installing The Unit Horizontally On The Floor; Using The Rubber Feet To Tilt The Unit - Yamaha STAGEPAS 200 Owner's Manual

Installing the Unit

Installing the unit horizontally
on the floor
Place the unit on a horizontal floor surface with the rubber
feet still attached to the bottom panel.
NOTICE
If you place the unit without the rubber feet attached on the
bottom, the floor may be scratched.
Using the rubber feet to tilt the
unit
You can use the rubber feet to tilt the unit so that the grille is
slanted by 30° or 60°.
Be sure to follow the steps below to attach two rubber feet to
the unit.
Slanted upward by 30°
1
Remove both rubber feet from the bottom
panel.
2
Attach the rubber feet to the unit as shown
in the illustration below.
B
A
16
STAGEPAS 200BTR STAGEPAS 200 Owner's Manual
3
Make sure that the groove of each rubber
foot will bite the side frame of the unit.
4
Place the unit with the rubber feet on the
bottom.
30°