Yamaha STAGEPAS 200 Owner's Manual page 6

• Do not keep this product in a place subject to extremely low air
pressure.
Otherwise, it may explode, resulting in fire or injury.
• Do not subject the batteries to mechanical shock or drop.
Failure to comply may result in fire, electric shock, malfunction.
• Keep this product out of reach of children. This product is not
suitable for use in locations where children are likely to be
present.
• Replace Li-ion battery with (Yamaha Corporation, cat. no. BTR-
STP200) only. Use of another battery may present a risk of fire
or explosion.
Wireless unit
• Do not use this product near medical devices or inside medical
facilities. Radio waves from this product may affect electro-
medical devices.
• Do not use this product within 15 cm (6 in) of persons with a
heart pacemaker implant or a defibrillator implant. Radio
waves from this product may affect electro-medical devices,
such as a heart pacemaker implant or defibrillator implant.
CAUTION
Always follow the basic precautions listed below to
avoid the possibility of physical injury to you or others.
These precautions include, but are not limited to, the
following:
Power supply
• When removing the electric plug from the product or an outlet,
always hold the plug itself and not the cord. Pulling by the cord
can damage it.
Location and connection
• Do not place the product in an unstable position or a location
with excessive vibration, where it might accidentally fall over
and cause injury.
• Keep this product out of reach of children. This product is not
suitable for use in locations where children are likely to be
present.
• Do not block the vents. This product has ventilation holes at
the top/rear to prevent the internal temperature from
becoming too high. In particular, do not place the product on
its side or upside down. Inadequate ventilation can result in
overheating, possibly causing damage to the product(s), or
even fire.
• To ensure proper heat dissipation of the product, when
installing it:
- Do not cover it with any cloth.
- Make sure the top surface faces up; do not install on its sides
or upside down.
- Do not use the product in a confined, poorly-ventilated
location.
Inadequate ventilation can result in overheating, possibly
causing damage to the product(s), or even fire. Make sure that
there is adequate space around the product: at least 10 cm
above, 10 cm at the sides and 10 cm behind.
• Do not carry or transport the device unless it is disassembled.
Otherwise, you might be injured if the speaker or spacers strike
your head or body.
• Do not place the product in a location where it may come into
contact with corrosive gases or salt air. Doing so may result in
malfunction.
• Before moving the product, remove all connected cables.
• Do not use the speaker's handles for suspended installation.
Doing so can result in damage or injury.
• Do not hold the bottom of the product when transporting or
moving it. In doing so, you may pinch your hands under the
product, and result in injury.
• Do not press the rear panel of the product against the wall.
Doing so may cause the plug and speaker cable to come in
contact with the wall and detach from the power cord,
resulting in short circuiting, malfunction, or even fire.
Maintenance
• Remove the power plug from the AC outlet when cleaning the
product.
Handling caution
• Do not rest your weight on the product or place heavy objects
on it.
• Do not operate the product if the sound is distorting.
Prolonged use in this condition could cause overheating and
result in fire.
Battery
• Never handle batteries with wet hands.
• Do not rest your weight on the product or place heavy objects
on it.
• Always make sure all batteries are inserted in conformity.
Failure to do so might result in overheating, fire, or battery fluid
leakage.
• When storing or discarding batteries, insulate the terminal area
by applying tape, or some other protection. If the terminal of
the battery touches other batteries or metal objects, it may
cause overheating, fire, or battery fluid leakage.
• Charge only with a specified charger. Charging with an
unspecified charger may cause leakage, overheating,
explosion, or malfunction.
• Charges within the specified charging temperature range.
Charging at a temperature outside the range may cause
leakage, overheating, explosion, or damage.
STAGEPAS 200BTR STAGEPAS 200 Owner's Manual
PA_en_12 2/2
7