Table of Contents
Advertisement
BRKT-J23 Wall Mount Kit Installation Guide
Installing a
Switch with the
Front Panel
Facing UP
To install the switch on a wall horizontally, install the brackets to support
the switch from the sides as shown in Figure 8.
x
Figure 8. Installing the Brackets to Support the Switch
To install the switch on a wall horizontally, perform the following
procedure:
1. Review the Safety Precautions in the installation guide of the switch
you are installing.
2. If the rubber feet were previously attached to the switch, remove them
as shown in Figure 4 on page 13.
3. Orient the brackets against the bottom sides of the switch.
4. Have another person hold the switch with the brackets at the location
where the switch is to be installed, while you use a pencil to mark the
wall at the locations of the holes in the two brackets.
5. Pre-drill the marked locations on the wall marked in Step 4.
6. Install the plastic anchors into the wall in the holes for the two bottom
side brackets.
7. Position brackets on the wall and screw the screws through the holes
to attach the bottom brackets on the wall.
8. Make sure that the two brackets are installed securely.
9. Slide the switch into the brackets on the wall.
16
Advertisement
Table of Contents
