Table of Contents
Advertisement
BRKT-J23 Wall Mount Kit Installation Guide
Introduction
The BRKT-J23 wall mount kit allows you to install a switch to a wall.
Here are guidelines for installing a switch on a wall using the BRKT-J23
wall mount kit.
See the Installation Guide of your switch to find out if your switch
should be installed to a wall using the BRKT-J23 wall mount kit.
The height of the switch must be 38 mm (1.5 in).
If rubber feet are attached to the switch, remove them.
Review the safety precautions listed in the Installation Guide of
your switch before installing the switch.
Apply the BRKT-J23 brackets to the switch as shown in Figure 1.
See the Installation Guide of your switch for approved installation
orientations of the switch.
Figure 1. Orientations of the Brackets to a Switch
10
Advertisement
Table of Contents
