Installing A Switch Using The Brkt-J23 Wall Mount Kit; What To Prepare; Installing A Switch With The Front Panel Facing Sideways - Allied Telesis BRKT-J23 Installation Manual

Installing a Switch Using the BRKT-J23 Wall Mount Kit

What to Prepare

Installing a
Switch with the
Front Panel
Facing Sideways
This section shows you steps to install a switch on a wall using the
BRKT-J23 brackets.
Before installing a switch on a wall, make sure that the following items are
ready.
One switch

One BRKT-J23 wall mount kit

Eight 4mm x 32mm wood screws for wall mounting (not included)

Eight plastic anchors for the wood screws (not included)

Phillips-head screwdriver

Pencil

Drill

Note
You must provide screws and plastic anchors to hold the brackets
securely to the wall, a Phillips-head screw driver, and a pencil, and a
drill.
To install the switch on a wall with the front panel facing sideways, perform
the following procedure:
1. Review the Safety Precautions in the installation guide of the switch
you are installing.
2. If rubber feet were previously attached to the switch, remove them as
shown in Figure 4.
Figure 4. Removing Rubber Feet from the Switch
3. Orient two brackets against the side of the switch.
Chapter 1: Installation Using the BRKT-J23 Kit
13