Advertisement
SECTION ONE: ASSEMBLY INSTRUCTIONS
MOUNTING THE LEGS:
1) Carefully lay the Grill on its back on a non-abrasive surface.
2) Use the Black Bolts, Washers and Nuts (see Detail "A") supplied in the Hardware Kit
(150) to install the Caster Legs (124) on the left end of the Grill and the Wheel Legs
(129) on the right end as shown in the diagram below. The Acorn Nuts (135) on the
Wheel Legs (129) should go toward the center of the Grill. Leave the Nuts loose
during this step.
3) Set the Grill upright to level and then tighten all Nuts.
INSTALLING THE HOPPER / BURNER ASSEMBLY:
NOTE: Do not remove the white, square Burner Gasket (90) from the Hopper / Burner
Assembly (31). Leave the tape securing the RTD Wiring in place until the Hopper /
Burner (31) is installed.
1) Slide the Hopper / Burner Assembly (31) into the square opening on the left end of
the Grill. Gently push the Hopper / Burner Assembly (31) into the opening until the
Burner Gasket (90) fits snugly against the left end.
2) Align the Nut Serts in the Hopper / Burner Assembly (31) with the bolt holes in the
Grill.
3) Place Zinc Flat Washers on four of the 3/4" long Hex Head Bolts. Insert the Bolts into
the Nut Serts from inside the Grill and tighten. Do not over tighten.
4) Remove the tape securing the RTD Wiring to the Hopper / Burner Assembly (31)
and the left end of the Grill. Push the Connectors together until fully seated. Holding
the RTD Wire from the Hopper / Burner Assembly (31), carefully slide the Protective
Sleeve over the connection (see diagram below). Place the RTD Wiring down
between the Grill and the Hopper / Burner Assembly (31).
Advertisement
