Honda HSM1380i Owner's Manual page 68

AUGER CLUTCH SWITCH
The auger and blower will start to turn when the drive clutch lever
and auger clutch switch is operated. Check around the snowblower
for safety before operating the lever and switch.
MAIN SHIFT LEVER
FAST
FAST
RANGE
LOW
SLOW
RANGE
SLOW
FAST
5) Push the auger clutch switch to
operate on the auger and blower.
The indicator (green) comes on
when you push the auger clutch
switch.
When the auger clutch switch is
pushed for four seconds or
longer, the protection function
gets armed. This stops the
auger and blower from turning.
The auger and blower keep
turning while the drive clutch
lever is squeezed. Push the
auger clutch switch again to
stop the auger and blower.
(Interlocking operation of the
drive clutch lever and auger
clutch switch)
6) Adjust the operating speed by
moving the main shift lever to a
position within the slow speed
range according to the volume
and nature of the snow, and clear
the snow.
Even when you are clearing the
snow, adjust the operating
speed as needed by operating
the main shift lever according
to the change of the volume
and nature of the snow.
When the snow is small in
volume or light in nature, move
the main shift lever to the high
speed side. Perform minor
adjustment of the main shift
lever to stabilize the operating
speed if necessary.
65