NewAir NEC1K6WH00 Owner's Manual page 18

Water filling
Before turning on the cooling/humidifying function, please add water to the
water tank. Before adding water, rotate the bobbing bracket by 90 degrees.
Then, pull out the water tank halfway and gradually fill to the maximum
indicated level. When finished, push the water tank back in and rotate the
bobbing bracket back to its original position.
Please pay attention to the water level in the water tank when adding water
manually (as shown in picture 5).
1. When adding water, please be careful to fill at least to the minimum
indicated water level and not to exceed the maximum indicated water
level.
2. Be sure to use clean tap water to fill the water tank.
3. Tips: When the machine is used for the first time, it may be accompanied
by a slight smell, and the water in the tank may bear a slight discoloration.
These are normal, non-toxic, and harmless phenomena and will not affect
your health.
4. If ice pack is included, the water level should not be higher than the MAX
line of the water tank.
Remote control operation:
1. First, open the battery cover of the remote control and insert a 3V CR2032
battery. Battery cover opening method: hold in the direction of arrow 1
first to remove the button on the battery cover, then draw it out in the
direction of arrow 2.
2. Please aim at the receiver when using the remote control.
www.newair.com
EN
18