Table of Contents
Advertisement
1
R
cycling refrigerated air dryer
2.8
controller instructions
User interface - with CAREL
Changing set points
General
The factory-programmed set point normally meets the nominal capacity of your dryer and is also appropriate
for all the fl ows lower than nominal. A change of set point may be necessary to obtain a dew point higher
than the standard dew point to allow fl ows higher than nominal capacity or in a par cularly hot environment.
Adjustment
•
Press the set bu on for one second, the digital display will show set and then the current set point will
be fl ashing.
•
Use the Up and Down arrow to modify the set point based on applica on requirements.
32-50°F adjustment if possible through a programming change
•
To record the new value, press the SET bu on. The digital display panel reverts to its normal status (i.e.
stops fl ashing) and indicates the varia on between the measured value and the set point.
l
18
6
Advertisement
Table of Contents
