2-10. BASE UNIT (BU-D1BD73)
Note 1: This illustration sees the top panel block from base unit side.
5 two vibration proof rubbers
1 four floating screws
(PTPWHM2.6)
8 base unit
(BU-D1BD73)
2-11. OPTICAL PICK-UP BLOCK (DA11MMVGP)
Note 1: When disconnecting the wire (fl at type) (16 core) of optical pick-up block, solder the short-land.
7 optical pick-up block
(DA11MMVGP)
1 Remove four solders.
(green)
3
5 tapping screw (P2)
(EC709iP)
2 stopper (D1)
4 two vibration proof rubbers
(red)
6 four claws
Note 2: Four claws might be fixed by bond.
7 cover (D1)
2 Solder the short-land.
Note 2: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the wire (flat type) (16 core).
6 shaft (support)
3 wire (flat type) (16 core) (optical pick-up)
4 BD73 board block
HCD-EC709iP/EC909iP
11