Initializing The Gps Receiver; Setting The Volume - Navigon 7200T User Manual

Basic Operations
Starting the NAVIGON 7200T

Initializing the GPS receiver

Note: If possible, position the device with a clear line of sight to the sky to successfully
receive messages from the GPS satellites.
Note: GPS initialization requires data from at least three satellites. If GPS data is not
available, the receiver will not initialize.
Note: It can take up to 20 minutes to initialize the integrated GPS receiver for the first
time.
Note: Each time you turn on the device, GPS receiver initialization begins. When GPS
data is available, reception starts within one minute.
If the navigation device has been switched to standby for more than a week, the next ini-
tialization can take up to 10 minutes.
In the upper right-hand corner of the display, the GPS symbol appears. As soon as
data from at least 3 satellites is received, the symbol changes to
Note: If the GPS symbol displays GPS Ready after considerably less than 20 min-
utes, it is advisable to leave the receiver switched on for at least an additional 15 min-
utes to ensure reliable operation.
Caution! The GPS receiver requires a constant supply of power. Leaving the device
plugged into your cigarette lighter for a longer period with the vehicle turned off could
drain the vehicle battery.

Setting the volume

The volume of the spoken driving instructions can be adjusted during navigation.
With a map displayed:
1. Tap
The volume bar opens. It contains three buttons for adjusting the volume:
2. Tap
The volume bar closes.
Note: When you mute the volume, an icon
the screen, next to the bluetooth, battery, traffic, and GPS icons. The icon disappears
when the volume mute is turned off.
22
(Volume .
)
(Louder)
(Softer)
(Mute on/off).
(Volume again.
)
NAVIGON 7200T User's Guide
NAVIGON, INC.
(
appears in the upper right corner of
.
GPS Ready)
November 2008
Version 1.0