Advertisement
Step 6:
Check for any slackness of the plate
cluster around the periphery of the Side
stand and tighten the Nuts to torque, as
per specification in the BOM table.
The final mounted condition of the Large
Side Stand will be as shown in the drawing
above.
Copyright By SRC
Design and Specification are subjected to change
Step 5:
Insert the Upper Plate (3), through the
cut-out and clearing the gusset in the Side
Stand.
Slip-in the Nut M6 (4) – 4 off from the top
and secure the threads in the 4 off
Countersunk screws, as shown.
Page 5
Advertisement
