Technical Specifications; Machine Information - VONROC AG505AC Original Instructions Manual

occur. Investigate and take corrective action to
eliminate the cause of wheel binding.
d) Do not restart the cutting operation in the
workpiece. Let the wheel reach full speed and
carefully re­enter the cut. The wheel may bind,
walk up or kickback if the power tool is restar-
ted in the workpiece.
e) Support panels or any oversized workpiece to
minimize the risk of wheel pinching and kick­
back. Large workpieces tend to sag under their
own weight. Supports must be placed under the
workpiece near the line of cut and near the edge
of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket cut"
into existing walls or other blind areas. The prot-
ruding wheel may cut gas or water pipes, electri-
cal wiring or objects that can cause kickback.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a mini-
mum thickness of 1.5 mm
sion cable reel, always fully unroll the cable.
• If the supply cord of this power tool is damaged,
it must be replaced by a specially prepared sup-
ply cord available through the service organiza-
tion.

2. MACHINE INFORMATION

Intended use
Your angle grinder has been designed for grinding
masonry and steel materials without the use of
water. For cutting, a special protection guard must
be used (not included).
Not suitable for construction site usage.
WWW.VONROC.COM

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Grinding disc
Diameter:
Bore:
Spindle thread
Weight
Noise and vibration
Sound pressure level L
Acoustic power level L
Vibration
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 60745-1 and
EN 60745-2-3; it may be used to compare one tool
. If you use an exten- with another and as a preliminary assessment of
2
exposure to vibration when using the tool for the
applications mentioned.
• the vibration emission during actual use of the
• need to identify safety measures to protect the
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keep-
ing your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-3.
1. Spindle lock button
2. Screw
PA
WA
Wear hearing protection.
power tool can differ from the declared total
value depending on the ways in which the tool
is used;
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when
it is running idle in addition to the trigger time).
EN
AG505AC
220-240 V~
50/60 Hz
850W
12000/min
125 mm
22.2 mm
M14
2.05 kg
86.4 + 3 dB(A)
97.4 + 3 dB(A)
6.334 + 1.5 m/s2
7