Table of Contents
Advertisement
Installation (continued)
Suspending the projector
Bracket fixing screw
Attachment plate
Hooks
Hooks
Bracket fixing
screw
Rear of projector
8 - ENGLISH
Safety fixing
(This figure is
screw (M4)
viewed from
below.)
Bracket fixing screw
Hooks
Safety fixing
screw (M4)
1 Loosen the bracket fixing screw of the attachment
plate and the safety fixing screw.
2 Insert the hooks of the adjustable bracket unit
into the three holes in the attachment plate, then
rotate the projector in the direction of the arrow.
Attention
z Loosen the bracket fixing screw and the safety
fixing screw as shown in the figure on the left be-
fore inserting the hooks of the adjustable bracket
unit.
z Hold the projector firmly until inserting the hooks
of adjustable bracket unit into the holes in the at-
tachment plate and the rotating the projector are
finished.
WARNING
■ Mounting and installation must be
carried out by two or more persons.
3 Temporarily tighten the bracket fixing screw.
Attention
z After the installation angle adjustment on page
9, tighten the bracket fixing screw securely with
fingers.
4 Use a torque screwdriver to tighten the safety fix-
ing screw.
Advertisement
Table of Contents
