Charging A Hot Or Cold Battery Pack; General Maintenance; Wall-Mount Holes - EGO Power+ CH3200E Original Instructions Manual

Fully charged
Defective
Cold/Hot
battery

CHARGING A HOT OR COLD BATTERY PACK

If the temperature of a battery pack being charged is
outside the normal range, LED Indicator 2 will remain red.
Cool down the battery pack or warm it up. If charging
does not restart when the temperature of the battery pack
returns to normal, reinsert the battery pack.
DEFECTIVE BATTERY PACK OR CHARGER
If the charger detects a problem, LED Indicator 2 will
flash red.
1. Reinsert the battery pack. If LED Indicator 2 flashes
red again, try a different battery pack.
2. If the second battery pack charges normally, dispose
of the faulty battery pack (please refer to the
instructions in the battery pack manual).
3. If a different battery pack cannot solve the problem,
unplug the charger and wait for LED Indicator 2 to go
out. Then reconnect the plug to the power supply. If
LED on charger still display defective, the charge may
be defective.

WALL-MOUNT HOLES

The charger has wall mounting holes for convenient storage
(Fig. A-6). Install two screws in the wall 101.6 mm apart. Use
screws sufficiently strong to support the combined weight of
the charger and battery pack.
To prevent the battery pack from falling off, hang the charger
only in the vertical orientation.
MAINTENANCE
WARNING:
To avoid serious personal injury, be sure
to remove the battery pack from the tool before cleaning
or maintenance.
WARNING:
When servicing, use only identical EGO
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician at an EGO Service Center.
Solid Green Solid Green
Flashing Red
Off
or off
Off Solid Red
compressed dry air to clean the charger. If this is the only
way for cleaning, be sure to wear safety goggles or safety
glasses with side shields. If it is a dusty process, wear a
dust mask.
be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts, because
most plastics are susceptible to damage from various types of
commercial solvents. Use a clean piece of cloth to remove dirt,
dust, oil, grease, etc.
gasoline, petroleum-based products, penetrating oils,
etc. come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic, which may result in
serious personal injury.
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician at an EGO Service Center.
Charging is complete.
Off
Maintenance charging.
The battery pack or
Off
charger is defective.
Battery pack is too hot or
Off
too cold.
WARNING:
It is not recommended to use
WARNING:
If the supply cord is damaged, it must
WARNING:
Do not at any time let brake fluids,
WARNING:
When servicing, use only identical EGO
320W CHARGER — CH3200E
EN
7