Cm Series Pumps-Intake And Discharge Flanges - Waterous CM Series Installation Manual

Safety
CM Series Pumps—Intake and Discharge Flanges
CM Series pumps are available with angle-compensated or non-angle-compensated front and side discharge flanges—pump without angle compensation shown
below. Pumps with angle compensation feature a front discharge flange angled at 4° and side discharge flanges with holes machined at a 4° rotation. This option
ensures that the discharges align with the operator panel after installation.
1
2
4
Feature Feature
1 Center discharge flange
2 Side discharge flange
3 Front discharge flange
4 Intake flange
5 Tank-to-pump flange
6 Priming valve mounting pad
Introduction
6
5
Description Description
Water exits the pump through this discharge. In applications where discharge plumbing is not needed, a cover is available.
Water exits the pump through the side discharges. Optional discharge fittings and plumbing are available to connect to the
discharge flanges.
Water exits the pump through this discharge. In applications where discharge plumbing is not needed, a cover is available.
Water enters the pump through the intakes. Optional intake fittings are available to connect to the intake flanges.
This is where the tank-to-pump valve or fitting is mounted on the pump.
This is where the priming valve is mounted on the pump. In applications without a priming valve, a cover is available.
Product Overview
3
|
9 56
Installation
2
4