Download Print this page
   

Advertisement

ASSEMBLY INSTRUCTIONS
Mobile Whiteboard Stand
IWSTAND
Made in USA
Copyright © 2007, NEC Display Solutions of America. All Rights Reserved

Advertisement

   Related Manuals for NEC IW77

   Summary of Contents for NEC IW77

  • Page 1: Assembly Instructions

    ASSEMBLY INSTRUCTIONS Mobile Whiteboard Stand IWSTAND Made in USA Copyright © 2007, NEC Display Solutions of America. All Rights Reserved...

  • Page 2: Safety Information

    Retain these instructions for future reference. Intended Use: The IWSTAND was intended for indoor use with the IW77 Interactive Whiteboard only. Use outdoors or on an unstable or unlevel floor is not recommended and could create a potentially unsafe operating condition.

  • Page 3: Parts List

    The following instructions will guide you through the steps for assembly. Estimated assembly time is 15 minutes. If you require assistance or are missing parts, contact NEC by email at http://www.necdisplay.com/SupportCenter Required tools are: Hex key (5mm supplied) It is important to layout parts prior to beginning assembly.

  • Page 4: Frame Assembly

    Finally attaching the lower horizontal member ( 4 - Red ) to frame verticals ( 2 and 3 ) with a screw ( 14 ) and © NEC Display Solutions of America. All Rights Reserved, 2007...

  • Page 5

    (14 ). After screw is tight, tighten the two support bracket screws. Attach end cap (18 )with fastener(19 )to each end of leg extrusion and top horizontal rail. © NEC Display Solutions of America. All Rights Reserved, 2007 2, 3...

  • Page 6

    Philips head machine screw, remove it and (13) install bracket to the bottom edge with the “circle” opening facing the front of the board. Repeat for the other bracket. © NEC Display Solutions of America. All Rights Reserved, 2007. Detail B Detail C...

  • Page 7

    In the travel position the IWSTAND Stand is quite stable for movement. For safe transport across rough surfaces or ramps and inclines, the user should request the assistance of a second person. Caution © NEC Display Solutions of America. All Rights Reserved, 2007.

  • Page 8

    NEC warrants to the original purchaser that its stands are free from defect in material and workmanship. While it is expected that you will be extremely pleased with the quality of your new NEC product, in the unlikely event that you have a problem caused by defects in materials or workmanship, NEC will repair or replace the defective stand at its option and expense.

This manual also for:

Iwstand

Comments to this Manuals

Symbols: 0
Latest comments: