Attaching The Base; Place The Display On A Solid Surface; Antenna Connection - NEC E322 User Manual

Attaching the Base

E322 / E422 / E462
1� Place the display face down on a soft and flat surface to prevent
scratching and damage�
2� Carefully align the base to the stand and fasten the screws with a cross-
head screwdriver�
CAUTION: The base of the stand is very heavy� Install with care to avoid injury
such as dropping the base onto one's foot�

Place The Display On A Solid Surface

Ensure that the LCD display is
placed in a position to allow free flow
of air� Do not cover the ventilation
openings on the back cover� Do not
place the display near any open
flames. Do not allow the display to
be placed in an environment where
it can be exposed to heat, direct
sunlight, or rain and water� Do not
expose the equipment to any liquid�

Antenna Connection

Unless your LCD display is connected
to a cable TV system or to a centralized
antenna system, a good outdoor color
TV antenna is recommended for best
television performance� However, if you
are located in an exceptionally good
signal area that is free from interference
and multiple image ghosts, an indoor
antenna may be sufficient.
When using a 75-Ohm coaxial cable system, connect the CATV coaxial cable
to the AIR/CABLE (75-Ohm) terminal� Or if you have an antenna, connect the
coaxial cable to the same AIR/CABLE terminal�
E552
English-11
Min
1 m