Sony WH-1000XM2 Service Manual page 8

WH-1000XM2
2-7. ORNAMENT (R) ASSY (R-CH)
Installation osition of the orna ent adhesi e
MIC FF holder
electret cap
microphone
guide line
8 ornament
adhesive
9 ornament (R) block
qs ornament
(R) assy
terminal side
Folding the flexible flat cable (12 core)
Before installing the flexible flat cable (12 core) to the board,
fold it with the following procedure.
black
line
8
ornament
housing
adhesive
block
(R-ch)
guide line
lower side
terminal side
7 Draw the flexible flat cable
out of the connector.
R SUB
board
6 Unlock the
connector.
(CN851)
R TPAD
board
0 Unlock the
connector.
(CN901)
qa flexible flat cable
(12 core)
black
black line
line
black
Turn
line
over.
5 Peel the MIC B sheet off of
the housing block (R-ch).
ornament (R) block
MIC B sheet
– R-ch –
housing block (R-ch)
lower
1 Peel the cover
side
stopper adhesive
off of the housing
block (R-ch).
How to install the flexible flat cable
When installing the flexible flat cable, ensure that the colored line
is parallel to the connector after insertion.
OK
Insert straight into the interior.
flexible flat
cable
colored line
connector
Installation direction for
the flexible flat cable (12 core)
OK
to R SUB board
black line
Turn
to R TOUCH board
over.
housing block
(R-ch)
ornament adhesive
4 four screws
(P2.0 8.0)
1 Peel the cover
stopper adhesive
off of the housing
block (R-ch).
2 cover stopper
adhesive
3 screen
2 cover stopper adhesive
NG
Insert at a slant.
flexible flat
cable
colored line
connector
NG
to R SUB board
black line
to R TOUCH board