Sony WH-1000XM2 Service Manual page 10

WH-1000XM2
2-9. SLIDER UPPER ASSY
Note 1: The left and right slider upper assys can be removed using the same procedure.
This explanation uses illustrations from the right side.
Note 2: Lubricant (SANKOL) is applied to the slider upper assy and slider lower assy.
Be careful when handling so that you do not touch the portion applied with the
lubricant (SANKOL). For the application location of the lubricant (SANKOL),
refer to "HANDLING OF SLIDER UPPER ASSY AND SLIDER LOWER
ASSY BY LUBRICANT APPLICATION" on page 2.
slider block
3 Extend the slider
block in the direction
of the arrow.
5 Insert the jig into both sides and move it in the direction
of the arrows to peel off the slider adhesive.
Note 3: When using the jig, be careful so that the slider upper
assy and slider lower assy are not damaged.
slider
adhesive
10
– R-ch –
slider upper assy
slider upper assy
– Inner view –
slider
adhesive
Note 4: Before installing
the slider upper
assy, peel off the
release paper of
the slider adhesive.
claw
2 two tapping
screws (P2)
(L = 5.0 mm)
1 Fold the
housing block
in the direction
4 Insert the jig from the screwed side and
of the arrow.
remove the two claws.
Note 3: When using the jig, be careful so that
housing block
7 Slide the slider
upper assy in
the direction
of the arrow.
slider
lower
assy
6 Remove the entire housing block
by removing the slider lower assy
in the direction of the arrow.
JIG
When disassembling the unit, use the following jig.
Part No.
9-913-402-33
slider upper assy
claw
slider lower assy
the slider upper assy and slider lower
assy are not damaged.
8 slider upper assy
housing block
Description
TOOL FOR DISASSEMBLING