Sony WH-1000XM2 Service Manual page 12

WH-1000XM2
2-11. SHAFT COVER
Note 1: The left and right shaft covers can be removed using the same procedure.
This explanation uses illustrations from the right side.
Note about installing the shaft cover
Note 2: When installing the shaft cover,
be careful so that the relay cable
does not obstruct the screw hole.
relay cable
screw hole
housing block
2 screw sheet
Note 3: When removing a screw (M1.7), a screw
sheet is attached to the screw (M1.7).
Therefore, use a new screw sheet only
when replacing a screw (M1.7). If a screw
(M1.7) will not be replaced, it can be
attached without affixing a new screw sheet.
2-12. CONFIRMING OPERATION OF THE SLIDER BLOCK
• If the slider upper assy, slider lower assy, and shaft cover were replaced, make sure to confi rm the operations below.
1. The left and right housing blocks fold smoothly.
2. The left and right slider portion slide without resistance.
12
shaft cover
1 screw (M1.7)
(L = 3.0 mm)
housing block
2 screw sheet
Note 3: When removing a screw (M1.7), a screw
sheet is attached to the screw (M1.7).
Therefore, use a new screw sheet only
when replacing a screw (M1.7). If a screw
3 shaft cover
(M1.7) will not be replaced, it can be
attached without affixing a new screw sheet.
1 screw (M1.7)
3. There are no gaps when the slider portion are closed.
OK
No gap.
(L = 3.0 mm)
– R-ch –
NG
Gap.