Sony WH-1000XM2 Service Manual page 5

2-3. ORNAMENT (L) ASSY (L-CH)
5 Peel the MIC B sheet off of
the housing block (L-ch).
housing block
(L-ch)
ornament adhesive
7 Peel the NFC adhesive
off of the ornament (L)
assy.
q; ornament
(L) assy
groove
6 Draw the NFC wire
out of the groove.
groove
NFC wire
2-4. LOWER COVER (L) (L-CH)
1 three tapping screws
(P2) (L = 5.0 mm)
2 lower cover (L)
– L-ch –
ornament (L) block
MIC B sheet
9 ornament
adhesive
8 NFC
adhesive
L NFC board
lower side
1 Peel the cover stopper adhesive
off of the housing block (L-ch).
L NFC board
Note: For the lower cover (L), lubricant (SANKOL) is applied to the areas
lower side
MIC FF holder
ornament
adhesive
electret cap
microphone
guide line
guide line
– –
housing block (L-ch)
2 cover stopper adhesive
indicated in the figure below. If the lower cover (L) is removed,
be careful so that you do not touch the indicated areas.
Also, lubricant (SANKOL) is not applied to the repair parts for the
lower cover (L). Apply lubricant as necessary before installing them.
– Inner view –
lower side
WH-1000XM2
housing block
(L-ch)
lower side
4 four screws
(P2.0 8.0)
1 Peel the cover stopper adhesive
off of the housing block (L-ch).
2 cover stopper adhesive
3 screen
lower
cover (L)
5